Tool Mounted Operation and Maintenance Manual Holder Additional weld-on serrated steps on the blade ensure safe receiver adjustment, install, or removal. Serrated bolt-on step provides safe ingress and egress from machine cab. Standard fixed masts provide great performance for single or dual laser technology configurations as well as supporting 3D technology. Optional side wings allow the operator to make the blade wider and carry material similar to box blades. These wheels are air filled and will provide balance for the blade in both automatic and manual operation. Independent Front Axle with Dual Wheelsĭual front wheels are mounted on an independent axle and on casters to provide stability in both directions of travel. The hydraulic valve and ECM (Electronic Control Module) are enclosed and mounted within the frame of the tool, protected from damage. Then, a single harness routes to the control module in the cab or on the tool. Technology components are centrally located and simply route to their respective harnesses back to this location on the tool. Dual Parabolic Mirrorsĭual parabolic mirrors provide full visibility to the front cutting edge allowing the operator to see how much the blade is loading and see out to the corners of the blade. Wear indicating cutting edges feature 20% more wear material on the ground engaging section of the edge and also indicate when it is time to flip (center section only) or replace the edge. Flowing material will easily find low spots and improve grading and leveling performance. Curved MoldboardĬurved moldboard allows for material to roll and fold, improving capacity and performance. Cat Grade (GPS and UTS), EW GO!, Total Station. Grader Blade attachment is external reference ready. Then the attachment maintains that desired slope during operation, even when the machine slope changes. With cross slope enabled, the operator selects the desired cross slope of the blade by placing the blade to the desired position. The operator will see attachment blade slope as well as angle of the blade. The dedicated screen of the Smart Dozer provides the operator with feedback on the orientation of the attachment. ![]() ![]() The right joysticks now operate the attachment. The left joystick maintains control of the machine drive functions. Attachment Control ModeĪttachment Control Mode (manual) turns the D3 and Smart Grader into a machine that is controlled more intuitively for the job at hand. The Smart grader blade brings cross slope to Skid Steer Loader and Compact Track Loader platforms. There is an assist feature of the blade that takes the unit beyond Smart. Cat® Smart Grader Blade attachments are for cutting, moving and grading dirt, gravel, sand and virtually any other material used as a base.
0 Comments
Leave a Reply. |